Web Analytics RiceHigh's Pentax Blog: LiFePO4 AA Batteries - Part 2.5: More Voltage Measurements and Quick Comparison

Friday, November 11, 2011

LiFePO4 AA Batteries - Part 2.5: More Voltage Measurements and Quick Comparison

Here is the quick report. Tested the fully charged LiFePO4 in my K-x. I intentionally forced the AF assist flash light to light up that fires continuously in a chain and fired more flash shots afterwards. The AF is found to be fast and the camera operates flawlessly. Everything works fine as it should be (exposure and focusing accuracy are good) and of course the camera works obviously faster than using any NiMH batteries, as Energizer AA Lithiums (model L91) always do.

Tried also continuous Hi shooting mode for several chains of shots until the camera slows down, no problem of any. LiveView was also enabled so as to drain more battery juice purposely.

Now my K-x is even lighter than using 4 disposable AA Lithium of the L91), but the LiFePO4 batteries should be placed in the central two battery slots to enable better weight balance of which the difference can be noticed if they are placed differently elsewhere (for the different combinations of real and dummy hollow batteries) .

Okay, before I can really tell more about the battery life in actual use. I have done some more voltage measurements and comparison for the make-up voltage for fresh and used L91 against those of the LiFePO4 batteries as below. I used the AA battery holder/adaptor D-BH109 for my K-r to do the job and the measurements have been made at near the same time with the same voltmeter:-

Fresh L91, ~6.8V:-


Used L91, ~6.1V:-


Fresh LiFePO4, ~6.8V:-


Used LiFePO4, ~6.2V:-


So, it can be safely concluded that the voltage characteristics of 4 x L91s and 4 x LiFePO4s are very close and similar. The capacity of the LiFePO4s should be lower, though. I shall tell more about its exact real-life battery life later on by the picture counter, as the first set has not yet been exhausted but only that the voltage has been found to be decreased/dropped significantly already, as seen in the above.

Btw, I think my this battery (also an entry level camera hacking) project has been succeeded!~ :-D


Previous Related:-


LiFePO4 AA Batteries - Part 2: Unboxing

New Lithium Rechargable Battery Type in AA Format - LiFePO4

Comments (4)

Loading... Logging you in...
  • Logged in as
So you use two LiFePO4 batteries with two dummy AA batteries with K-x? Isn't it safe to put all four LiFePO4 batteries in K-x or am I missing something? Sorry, not so battery savvy here :D

How was K-x's battery meter? Did it show green at the start? I guess the auto battery recognizion was on?
2 replies · active 698 weeks ago
Michael A.'s avatar

Michael A. · 698 weeks ago

Each LiFePO4 AA cell has 3.2+V, not 1.2-1.5V as the standard AA. But it appears, the users buy these cells for their solar string lights, not a camera....
If you are not using one LiFePO4 battery with one dummy conductor as a pair, your device would be burnt!

After then, the LiFePO4 works flawlessly as just AA Lithium (Energizer L91) does, the battery meter shows the same and works correctly. The only difference is that LiFePO4 is rechargeable, whilst L91 is disposable, only.
It should be possible to use 4xLiFePO4 batteries, even though that would equal 13.6V under load. Just try it and report the results to us.

Post a new comment

Comments by